---
title: "EC-M11-EG-C5 – USER GUIDE"
description: "## **Programming**  The NORVI EC-M11-EG-C5 has a mini USB port for serial connection with the SoC for programming. Any ESP32-supported programming IDE can be used to program the controller. Follow this Guide to programming NORVI ESP32-based Based Controllers with Arduino…"
url: "https://norvi.io/docs/norvi-ec-m11-eg-c5-user-guide/"
updated: "2026-03-23"
category: "OTHER PRODUCTS / EC-M11-EG / EC-M11-EG-C5"
---

# EC-M11-EG-C5 – USER GUIDE

## **Programming** 

The NORVI EC-M11-EG-C5 has a mini USB port for serial connection with the SoC for programming. Any ESP32-supported programming IDE can be used to program the controller. Follow this Guide to programming NORVI ESP32-based Based Controllers with Arduino IDE.

SoC: ESP32-WROOM32
Programming Port: USB UART

## **8-pin Connector and wire harness**

![](https://norvi.io/wp-content/uploads/2024/09/345-17.jpg)

## **Pin Description**

| 8P Male | Wire color | I/O Configuration |
| --- | --- | --- |
| 1 | White | SCL |
| 2 | Brown | SDA |
| 3 | Green | - |
| 4 | Yellow | - |
| 5 | Gray | 3.3V+ / 5V+ |
| 6 | Pink | - |
| 7 | Blue | Power+ |
| 8 | Red | Power- |

## **I2C Communication**

| IC Type | ADS 1115 |
| --- | --- |
| Module Address | 0x49 |
| SDA | GPIO16 |
| SCL | GPIO17 |

### ****Programming I2C Communication****

```javascript

                #include <Wire.h>
// Define the I2C device address
#define DEVICE_ADDRESS 0x49

void setup() {
  Wire.begin(16, 17);  // SDA on GPIO16, SCL on GPIO17
  Serial.begin(115200);
}

void loop() {
  // Write data to the I2C device
  Wire.beginTransmission(DEVICE_ADDRESS);
  Wire.write(0x01);  // Replace with your data
  Wire.write(0x02);
  Wire.write(0x03);
  Wire.endTransmission();
  delay(100);
  // Read data from the I2C device
  Wire.requestFrom(DEVICE_ADDRESS, 3);  // 3 bytes of data
  if (Wire.available() >= 3) {
    byte data1 = Wire.read();
    byte data2 = Wire.read();
    byte data3 = Wire.read();
    Serial.print("Read Data: ");
    Serial.print(data1, HEX);
    Serial.print(" ");
    Serial.print(data2, HEX);
    Serial.print(" ");
    Serial.println(data3, HEX);
  }
  delay(1000);  // Delay for demonstration purposes
}
```
